How to draw a copper track from pin to pin?

an open source PCB editor for Microsoft Windows, released under the GNU General Public License.

How to draw a copper track from pin to pin?

Hit a pin, and click F2_Connect_To_Pin, that to start dragging connection.

How to draw a copper track from pin to pin

How to draw a copper track from pin to pin

Click on the box to the left, or enter net name manually.

How to draw a copper track from pin to pin

Select segment, then click F4_Route. Using the F1 and F2 buttons you can change the width of the track on the go. The values of the widths used must be specified in the project options. F3 As_Pad button sets the width equal to the width of the pad. When you press F3 again, the pad width is increased by the default clearance of the solder mask.For routing сompletion click F4_Complete button again.

How to draw a copper track

The last vertex will be highlighted. Press F3 to align the segments under 45 degrees. You can reduce angle for alignment by changing edit box “Angle”.

Draw a copper track from pin to pin

The minimum value 7,5 degrees will be set, if you select OFF.